1OWNER’S MANUALROBERT H. PETERSON CO. • 14724 East Proctor Avenue, City of Industry, CA 91746ImportantRead these instructions carefully and completely
10OPERATIONAL SAFETY INFORMATIONOPERATING YOUR UNVENTED GAS APPLIANCE SAFELY AND CORRECTLYA. SOLID FUEL MUST NOT BE BURNED in a fi replace where this
11OPERATIONAL SAFETY INFORMATION (Cont.)OPERATING YOUR UNVENTED GAS APPLIANCE SAFELY AND CORRECTLYN. This appliance is intended for supplemental heati
12LOGS - PARTS LIST EFV-16/18 16/18" EVENING FYRE LOG SETITEM PART DESCRIPTION NO. NO. 1. EFVL-15BR Bottom rear log 2. EFVL-18BF-
13BURNER PARTS LIST ITEM DESCRIPTION NO. 1. Grate assembly 2. Valve assembly (natural) or Valve assembly (L.P.) 3. Ember burner 4. Piezo igni
148BURNER PARTS LIST (Cont.)G18-16/18-15(M)(P) ITEM DESCRIPTION NO. 1. Grate assembly 2. Valve assembly (natural) or Valve assembly (L.P.) 3.
1589BURNER PARTS LIST (Cont.) ITEM DESCRIPTION NO. 1. Grate assembly 2. Valve assembly (natural) or Valve assembly (L.P.) 3. Ember burner 4.
168BURNER PARTS LIST (Cont.)G18-16/18-01V(P) ITEM DESCRIPTION NO. 1. Grate assembly 2. Valve assembly (natural) or Valve assembly (L.P.) 3. E
17This appliance is for installation in a solid-fuel-burning fi replace (masonry fi replace or manufactured fi replace) with a working fl ue and construct
18INSTALLATION IMPORTANTFor all valves, the air MUST be purged from the gas line before the ODS pilot will light properly. The time taken to do this w
19NATURAL GASMANUAL PRESSURE MILLIVOLT PRESSURERegulator pressure reading: 3.5" w.c. Outlet pressure reading:(Flame adjustment on HIGH)3.5"
2TABLE OF CONTENTSL-F2-098REV 10 - 14052814003 SPECIFICATIONS AND REQUIREMENTS4 IMPORTANT SAFETY INFORMATION5 VENTILATION AND CONFINED SPACE SAFETY
20INSTALLATION (Cont.)GLOWING EMBER PLACEMENTThe Glowing Embers are supplied in a single bag (Fig. 20-1). It is important that the embers be used in t
21WOOD CHIP PLACEMENTThe decorative wood chips that are provided with the log set are for aesthetics only and do not affect operation of the G18 serie
22INSTALLATION (Cont.)Fig. 22-4ODS pilot (in rear)Main burner portsEmber burner portsGas valveCarryover port location(for fl ash tube)Flash tubeCLEANIN
23Only limited cleaning will be required under normal use of the unvented gas log set.TO CLEAN THE LOG SET 1. Remove the log set and embers. Use a va
24Observe the fl ames. The main burner fl ames should be blue at the base and a combination of blue/yellow at the body and at the tips. They should be 5
WARNINGIf you do not follow these instructions exactly, a fi re or explosion may result, causing property damage, personal injury, or loss of life.LIGH
26WARNING: If you do not follow these instructions exactly, a fi re or explosion may result, causing property damage, personal injury, or loss of life
271. Locate your Series 12 control valve (p. 15). Turn the control knob (Fig. 27-4) from the OFF position (see Fig. 27-1) slightly counterclockwise
28WARNING: If you do not follow these instructions exactly, a fi re or explosion may result, causing property damage, personal injury, or loss of life
29TROUBLESHOOTINGBURNER SHUTTING DOWN DURING OPERATIONPOSSIBLE CAUSE SOLUTIONSA. Insufficient or excessive gas pressureA1. Check gas pressure (Read G
3SPECIFICATIONS AND REQUIREMENTSWARNING: This appliance is for installation only in a:1. Solid-fuel-burning masonry or UL-127 factory-built fi replac
30TROUBLESHOOTING (Cont.)HIGH CO - CARBON MONOXIDE DETECTORS IN HOME TURNING ALARM ONA. High CO levels A. TURN OFF UNIT IMMEDIATELY.B. Call a quali
31TROUBLESHOOTING (Cont.)POSSIBLE CAUSE SOLUTIONSA. Low gas pressure A. Check gas pressure (see Section 1, A1 of this table).B. Drafts in room B.
32Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, CA 91746 Quality Check Date:_________________Burner Orifi ces Nat. L.P. Leak
4UNVENTED ROOM HEATER GENERAL SAFETY INFORMATIONA. WARNING: CARBON MONOXIDE POISONING MAY LEAD TO DEATH.When used without fresh air, gas appliances m
5Your vent-free gas burner system SHALL NOT BE INSTALLED IN A CONFINED SPACE or unusually tight construction unless provisions are made for adequate c
6MINIMUM CLEARANCES TO COMBUSTIBLES If the vent-free burner system is installed in a factory built fi replace, follow the manufacturer’s guidelines for
7MINIMUM CLEARANCES TO COMBUSTIBLES (Cont.)IF YOU CANNOT MEET THESE MINIMUM CLEARANCES, YOU MUST OPERATE THE VENT-FREE GAS BURNER SYSTEM WITH THE CHIM
8WARNINGTHIS APPLIANCE IS EQUIPPED FOR EITHER NATURAL OR PROPANE GAS.FIELD CONVERSION IS NOT PERMITTED.PRE-INSTALLATION AND FIREPLACE PREPARATION SAFE
9INSTALLATION SAFETY INFORMATIONINSTALLATION SAFETY GUIDELINESA. Carefully inspect the burner and log cartons for shipping damage. If any parts are m
Kommentare zu diesen Handbüchern